Carrying capacities of up to 250 kN
Mountable carrying consoles are suspended in pairs in separately fixed receiving hooks on the press change side. This allows for rapid dismantling and use on other machines. They are equally suitable for initial fitting and upgrading, and may significantly reduce the time and effort required for die exchange.
The die slides into the press via high-strength, hardened needle ball bearings, even with drive support if required. An impact-resistant coating contributes to the ruggedness of the consoles. Carrying capacities of up to 250 kN are covered by the standards product portfolio; supporting length from 500 to 3,500 mm are possible.
Swivelling consoles for narrow spaces
If there is only little space available in front of the press and frequent dismantling is not desired, swivelling models may be used. In contrast to other types, they are permanently fixed on the press bench and can be folded to the bench edge if required. The maximum possible carrying capacity amounts to 60 kN.
Supporting leg and electrical drive unit for dies with weights of up to 25 t
For weights of up to 25 t or large die widths, supporting legs provide for additional console stability. They can be adjusted in height by ± 60 mm so that floor unevenness may be compensated for easily. Positioning is facilitated by an additional electrical drive unit. An cost-efficient option is the combination of crank handle and transmission gear. It can be used for die weight of up to 6 t.
Automation is possible
If an additional electrical pull and thrust drive unit is selected, die placement and positioning can also be automated. The console is combined with roller or ball bars in the bench, and an appropriate inclusion in the press control is provided for.
Complete solutions for die exchange
ROEMHELD also implements all-in-one solutions for clamping and changing dies on the press bench. In this regard, the Group may draw on a comprehensive range of hydraulic clamping devices and modular hydraulic power units.